D7120 D7120-R3 D7120WDM D7120WDM-R3 D7130WDM D7130WDM-R3 IFS Fiber Module Installation & Operation Instructions P/N 1062848 • REV B • ISS 01AUG11
D7130WDM OPTICAL ETHERNET TRANSCEIVER UP 1 2 3 -- AUTO NEGOTIATE -- SPEED ifs FIBER IN/OUT International Fiber Systems Incorporated 10 BASE -T / 100 BASE - TX -- DUPLEX FIBER LINK FIBER LINK CONTACT AUTO NEGOTIATE ON/OFF POWER POWER -2 +12 VDC - 1 Simplex single mode fiber optic cable D7130WDM OPTICAL ETHERNET TRANSCEIVER FIBER IN/OUT UP 1 2 3 -- AUTO NEGOTIATE -- SPEED ifs International Fiber Systems Incorporated 10 BASE -T / 100 BASE - TX -- DUPLEX FIBER LINK FIBER LINK CONTACT AUTO N
D7100 C B A D E F G H J I 1 2 1 2 A Fiber Link B Auto Negotiate ON/OFF C Power D E F G H I J Auto Negotiate Switch Speed Switch Duplex Switch Power Connector Fiber Link Contact Connector 10 Base-T / 100 Base-TX Connector Fiber Optic Connectors (1 or 2 depending on model number) LED illuminates LED illuminates LED illuminates UP DOWN SWITCH # ON OFF 1 10 100 2 FULL HALF 3
D7100 NOTES Descriptions of Operation a. Fiber Link LED OFF = No fiber connection GREEN = Fiber connection b. Auto-negotiate LED OFF = Auto-negotiate off GREEN = Auto - negotiate on c. Default, recommended operation mode is auto - negotiate ON. When NOT using auto - negotiate mode, a cross over cable must be used for the copper link segment. Both ends of the copper link must be fixed at the same speed and duplex rating. d.
FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesirable operation. Changes or modifications not expressly approved by International Fiber Systems, Inc. could void the user’s authority to operate the equipment.
Contacting us For help installing, operating, maintaining, and troubleshooting this product, refer to this document and any other documentation provided. If you still have questions, contact us during business hours (Monday through Friday, excluding holidays, between 5 a.m. and 5 p.m. Pacific Time). Sales and support contact information North America Toll-free: 855.286.8889 in the US, including Alaska and Hawaii; Puerto Rico; Canada. Outside the toll-free area: 503.885.5700.
Product Disassembly Instructions for WEEE Per European Directive 2002/95/EC Waste Electrical and Electronic Equipment Required Tools: One number 2 Phillips (crosstip) screwdriver. One number 2 flat screwdriver. For the enclosed box version: 1. Locate and remove box cover securement screws. Usually, but not limited to, at least 4 screws. 2. Lift off box top cover. 3. Locate and remove securement screws for printed circuit board. 4.
Copyright Trademarks and patents Manufacturer Certification ACMA compliance Canada European Union directives © 2011 UTC Fire & Security. All rights reserved. Interlogix and IFS names and logos are trademarks of UTC Fire & Security. Other trade names used in this document may be trademarks or registered trademarks of the manufacturers or vendors of the respective products. UTC Fire & Security Americas Corporation, Inc.
