Data Sheet

©2001 Interlogix, Inc.
Interlogix reserves the right to change specifications without notice.
Barrier Bar and Tampruf are registered trademarks of Interlogix, Inc.
Wing Fit, Mini-Max., Maxi-Gap and Magnapull are trademarks of
Interlogix, Inc.
SENTROL 12345 SW Leveton Dr. Tualatin, OR 97062
PH 503.692.4052 FX 503.691.7566 www.interlogixinc.com
USA & Canada: 800.547.2556
Technical Service: 800.648.7424
FaxBack: 800.483.2495
Sentrol 2800T Series
C-1817-st5k-0101
NOTE:
* Gap distances are nominal make distance +/- 20%. Gap Specifications are
for switch to make. Break distance is approximately 1.1 to 1.5 times make.
Model Electrical Gap Distance
Number Loop Type Configuration (Make)* Lead Type
2804T Open or Closed SPDT 3/16" min., 5/8" max. #6 screw terminal
2807T Open or Closed SPDT 3/16" min., 5/8" max. #6 screw terminal
2808T Open or Closed SPDT 3/16" min., 5/8" max. #6 screw terminal
Ordering Information
R
Magnet
Conduit
(.50 threads)
5.25"
13.34 cm
2.00"
5.08 cm
Switch
.75"
1.92 cm
1.50"
3.81 cm
.813"
2.06 cm
Mounting holes not accessible
when cover is in place
5.75"
14.61 cm
#10-24 thread
R
Architects and Engineering Specifications
Switch and magnet housings shall be die-cast alumi-
num. Switch housing dimensions shall be nominally 5.75"
(14.61 cm) L x 2.0" (5.08 cm) H x 1.5" (3.81 cm) D.
Mounting holes for #10 screws shall be on 5.25" (13.34
cm) x 0.75" (1.91 cm) centers. Switch housing lid shall
be attached on 5.25" (13.34 cm) x 1.5" (3.81 cm) spacing
with #10-24 screws. Fitting with 0.50" threads shall be
provided for direct connection to conduit. Magnet
housing dimensions shall be nominally 5.75" (14.61 cm) L
x 0.813" (2.06 cm) H x 1.5" (3.81 cm) D. Mounting holes
for #10 screws shall be on 5.25" (13.34 cm) centers.
Switch shall comprise three biased reed contacts, wired
in SPDT configuration, and include a plunger-type
tamper actuated on removal of cover. Connection to
switch shall be made by screw terminals.
2807T, 2808T
Switch shall include a magnetic tamper switch and an
optional pry tamper switch. It shall be fastened to the
mounting surface with a pry tamper plate mounted with
6" x 0.75" flathead screws on 2" centers. Model 2808T
shall include a remote test function.
2804T
Switch shall include a magnetic tamper switch and
optional resettable current limiting device. Switch shall
also include a tamper resistant, two-piece magnet.
Specifications:
Form C (2804T, 2807T, 2808T)
Voltage ................................................... 30 V AC/DC max.
Current ............................................................ 0.25 A max.
Power ................................................................ 3.0 W max.
Phone: [phone] - Fax: [phone] - Web: www.clrwtr.com - Email: [e-mail]