Reference Manual

DISTRIBUTION: INTERNAL + INTERLINK-U CUSTOMERS

Interlink-U ID Reference Manual

A device user can stop or extend Monitoring Timer from the interface. This feature is especially useful where

a device user is entering an environment where they may lose cellular/network signal for a specified amount

of time.

Activating the Monitoring Timer

On the Interlink-U ID, a user is required to manually activate a timer at the beginning of a period for however

long they would like to be monitored by the ARC Operators. The Timer can be activated for a minimum of

15 minutes, and up to a maximum of 8 hours. This is done as follows:

Select the Monitoring Timer icon from device’s home

screen (as highlighted).

On the next screen you can select the length of time you

want the Monitoring Timer to be active for. You use the

+ / - buttons to do this.

You must then select the ✓ on the right (as highlighted)

to activate the timer.

Once the Timer is active the Timer screen is displayed

which shows the length of time remaining.

To cancel or adjust the remaining time, you must once

again visit the Timer screen (as detailed above). Once

here, you should hold down the “cancel” button for 2

seconds, which will cancel the active timer.

Your device will let you know when the Monitoring

Timer is due to expire. You will feel a single long

vibration when there are 5 minutes left and the Timer

font will turn red.

You will feel a further 2 vibrations when 1 minute is left

on the timer.

The device will confirm expiry or cancellation of the

Timer by emitting 3 vibrations and a single audible tone.

At this point our ARC Operator will attempt to contact

you to confirm that you are safe and not at risk. Failing