Reference Manual

DISTRIBUTION: INTERNAL + INTERLINK-U CUSTOMERS

Interlink-U ID Reference Manual

Then select the ‘Red Alert’ icon on the device homepage

and hold down the “confirm” button on it for 2 seconds to

activate a Red Alert.

When activated the device’s screen will turn off unless a

button is pressed to wake it.

This is in place to ensure that the device remains discreet

during an active Alert.

When the screen is awake during an active Red Alert the

interface will display a timer showing the current Alert

length.

Figure 13: Red Alert via device interface

Via the Rip Plug:

If the Interlink-U ID is removed forcibly from a user’s body

which results in pulling of the ‘Rip Alarm’ Pin, out of the

device, then a Red Alert will be triggered.

Figure 14: Red Alert via Rip Pin

Incapacitation Alert

Interlink-U ID uses tilt, non-movement, and impact detection in combination to establish device user

Incapacitation. Typically, if the device detects a significant impact (or tilt) along with non-movement for a

period of 2 minutes (standard configuration), the unit will enter a pre-alert phase and start to vibrate to

make the user aware the device is going to alarm if left unchecked. If the device is not moved for a further

2 minutes, then it will automatically raise an Incapacitation Alert and contact our Alarm Receiving

Centre/Monitoring Center.

When an Incapacitation Alert is started, your Interlink-U ID emits three short vibrations to confirm the state;

and then opens a two-way voice call to the designated number and enables the microphone, so that an