User Manual

Technical Manual for Master Terminals of the Series IF 152x
Page 30
Routing entries of the previous example
With subnetworks
IF 152x (1) Subnet mask entry required, other input fields all set to 0.0.0.0
IF 152x (2) Subnet mask and routing entries required, preferably peer-to-peer, other input
fields all set to 0.0.0.0
Without subnetworks
IF 152x (1) No routing entries required, all input fields set to 0.0.0.0
IF 152x (2) Routing entries required, preferably peer-to-peer, other input fields all set to
0.0.0.0
Parameterization
The routing types, the subnet mask and the metric are specified with the OC menu $ netpar -r and
saved in the EE-PROM.
Subnet mask
# Enter the subnet mask with which the network administrator manages the master terminal in the
input field marked "Subnetmaske".
If no subnet is used for management, the input field must be set to 0.0.0.0
.
Peer-to-Peer Routing (not use)
# Enter the IP address of the target host on which the IF application (time recording/access control
program) is installed in the input field marked "Peer-to-Peer Routing".
Enter the IP gateway address via which the local network (master terminal) sends data in the input
field marked "Gateway address".
Enter the number of gateways to the host in the input field marked "Metric".
Network routing (not use)
# Enter the IP target address if connections to other systems are to be built up in the target network
in the input field marked "Network-Routing".
Enter the IP gateway address via which the local network (master terminal) sends data in the input
field marked "Gateway address".
Enter the number of gateways to the target network in the input field marked "Metric".
Default routing
# Only enter the IP gateway address via which the local network of the master terminal sends data in
the input field marked "Default-Routing".
Enter the number of gateways to the target network in the input field marked "Metric".
Save
# Enter „ j
“ in the input line if you wish to save the previous data without making further changes.
Enter „n
“ if you do not want to save the data or if you wish to change the previous data.
$ Points to Note:
• Up to two routing types can be parameterized. Always set the input fields of the other routing types
which are not needed to 0.0.0.0.
• Do not forget to save the changed values.
• Reset the master terminal after changes have been made by pressing the reset button or via the
menu $ oc -s
. The new parameters are active after the reset has been carried out.