User Manual

Accessorizing the Intert S1

Umbrellas

Umbrellas are the most widely used modiers in photography. Their ease-of-use and versatility makes them

quick to master; a go-to modier in many situations.

Umbrellas can be mounted to the S1 using the umbrella shaft mount on the bottom of the ash unit. The

shaft mount can accommodate the wide variety of Intert brand umbrellas and parabolic umbrellas as well

as most umbrellas up to a 3/8” (8mm) diameter pole. Make sure to securely tighten the thumb screw on the

umbrella mount.

Sync Cable

Sync cables allow the ash to be triggered by the camera via physical tethered connection. While sync

cables are the most economical way to trigger a ash, they will not allow you to make any adjustments to

the ash from the camera. They will also not allow you to use HSS or TTL.

A sync cable is included with your S1 and can be plugged into the sync port on the rear left side of the ash

unit and the corresponding sync port on your camera. To connect the cable to the light, insert the 3.5mm

(headphone jack) plug into the sync port on the light. Take the other end of the cable and connect it to the

PC terminal on your camera (*consult your camera user manual to locate the PC terminal on your camera.

Some camera models do not have a PC terminal and may require a separate adapter).

Remotes

The S1 is compatible with all Intert TTL Remotes as well as the Intert Manual Remote. Using these remotes

allows you to control all functions of the light wirelessly, though only the Intert

TTL remotes will be able to activate and control the TTL and HSS functions of

the S1. The Intert TTL remotes are brand-specic and must correspond to

the brand of camera being used. This remote mounts to your camera’s hot

shoe and communicates to the S1 unit without an additional receiver. Intert

Remotes are sold separately.

*Compatible remotes include:

-Intert TTL Remote for Canon

-Intert TTL Remote for Nikon

-Intert TTL Remote for Sony

-Intert Manual Remote (manual mode only)

Third Party Remotes

The S1 is compatible with all third-party remotes using a receiver via sync cable. While these remotes

ie. PocketWizard or Yongnuo, will allow you to trigger the S1, they will not allow you to make any power

adjustments from the camera or use TTL or HSS. All power adjustments must be done manually through the

back of the light when using third-party remotes.