User Guide
Using the Badger Unleashed
Powering On/Off
To power on your light, simply insert the battery to the battery compartment of the ash head until it clicks
and ip the power switch from “O” to “I”.
Adjusting the Flash Power
Your Badger Unleashed is packed with 250Ws of power. This power is adjustable over a 9-stop range and
can be adjusted in 1/10th of a stop intervals. Use the power adjustment dial on the back of your Badger
Unleashed to adjust the power from 10.0 (full power) to 2.0 (lowest power) in manual mode. Power is
displayed on the LCD screen. When in HSS mode, the power will only adjust from 10.0 (full power in HSS) to
8.0 (lowest power in HSS).
Using the Test Function
The “TEST” button will illuminate blue when the ash is charged and ready for use. The blue indicator light
will turn off immediately after the ash has red, and turn on again once the light has fully recycled. Recycle
is also indicated by an audible beep when the “BEEP” function is enabled.
Using the Modeling Lamp
To use the 15W LED modeling lamp, press the “MODEL” button on the back interface of the Badger
Unleashed to toggle through two different modeling lamp modes or turn it off.
• PROP - Toggle the modeling lamp to match proportionally with the ash power.
• FULL - Toggle the modeling lamp to use the modeling lamp on 100% power.
Setting Channels and Groups*
*Setting the control channel or group is only necessary when using the Intert remotes. If you are using a
third-party radio system or optical slave, you can skip this section. When using the Manual remote or Gen.
2 TTL remotes (2019) 15 channels will show, but only the rst 8 can be used with Gen. 1 TTL remotes.
Having 15 unique radio control channels allows you to use your lights in close proximity with another
photographer without interfering with one another. Press the “CH/GR” button to toggle between channel
selection and group selection modes. When the channel or group blinks on the LCD screen, you will be able
to turn the selection dial left or right to choose a new group or channel. When you reach the desired setting,
press the “CH/GR” button again until neither the channel nor group ashes and they both are solid. Make
sure the channel and group selected on your Badger Unleashed matches the selected channel and group
on your Intert remote when you wish to change the settings for that light remotely.
MODEL
www.intertphotographic.com 6
TEST
CH/GR