User Manual

Using the Badger Unleashed
Beep Button
Press the “BEEP” button to turn on or off the beeping sound for button presses, ash power adjustments,
and ash refresh notications.
Optical Slave Cell
The Optical Slave Cell allows the Badger Unleashed to be triggered from the ash pulse of another unit.
Press the “CELL” button to toggle on and off the Optical Slave Cell.
NOTE: Using the Optical Slave Cell requires direct line-of-sight between the lights. The Optical Slave Cell
can only be used in Manual mode in moderate to low ambient light.
Shooting Modes
When shooting with the Intert TTL remote, select from a manual shooting mode or the TTL (Through-The-
Lens) mode. Press the button beneath “MODE” on the TTL remote to toggle between shooting modes.
Sync Modes
When shooting with the Intert TTL remote, select from three different sync modes. Press the button
beneath “SYNC” to toggle the sync mode to rst curtain, second curtain, or HSS.
NOTE: Nikon users switch between 1st and 2nd-curtain sync via the camera and enable HSS by increasing
the shutter speed on their camera with the ash sync mode set to “Auto FP”. Sony users must set their
camera ash mode to “Wireless Flash” for the remote to communicate properly with the camera.
Using HSS (High-Speed Sync)
Use the Intert TTL remote to toggle the shooting mode of your Badger Unleashed to “HSS”. This shooting
mode will allow you to use shutter speeds of up to 1/8000 sec. and trigger the ash. The power range
readout will change to 8.0-10.0. These output levels do not directly correlate with the 8.0-10.0 ash in
manual mode. There will be a noticeable decrease in ash output, as the Badger Unleashed will divide the
power into a series of lower power ashes to allow for correct exposures at high shutter speeds.
www.intertphotographic.com 7
BEEP
CELL
MODE