User's Manual

Table Of Contents

9.0 Programming options:

- Auto-shut-down time. An auto-shut-down feature is available. If the radio has not been

used for a period of time the receiver automatically drops out the main line contactor. The

default setting is 1 hour. Auto-shut-down times can be set between 0 and 4 hours.

Typical selections are available on the programming data sheets in the back of this

manual.

- Pushbutton options. Each pushbutton is set by default to momentary (relay closes when

a button is pressed and opens when released), and

interlocked in opposed motion pairs

(UP-DOWN, EAST-WEST, SOUTH-NORTH). When set as momentary, they can be set

as un-interlocked. They can also be set as toggle (press once to close relay, press again to

open) or as

On-Off pairs (press On to close relay, press Off to open relay). When

programmed as toggle or On-Off, they will be set as controlled by Stop (opening

automatically when the STOP button is pressed). They can be reprogrammed by the

factory for uncontrolled by Stop (unaffected by STOP button); please call for more

information.

- Acceleration delay. Delay between actuation of relays for each of the detents of the

joysticks can be programmed. This delay time can be set between 0 and 4 seconds;

default is 0 seconds. Typical selections are available on the programming data sheet.

- R0 function. The R0 relay operates only when the START button is pushed after the

unit has already been started. It is by default set to momentary (closed when START

button is pressed, open when released). It can also be set to

toggle (push the START

button once to close, then push the button again to open), or inching (does not activate the

R0 relay, but instead only allows pushbuttons pressed, after pushing the START button,

to remain on for a preset length of time, no matter how long the button is held). For

inching, the inch time may be set to a minimum of 0.05 seconds or anywhere from 0.1 to

0.8 seconds in 0.1-second increments. Typical selections are available on the

programming data sheet.

Call Factory for more information 1-800-382-3558.