User Manual

June 10, 2021 Ecoh 915 Manual 1.0.3 Pag. 9 of 25
4.6. Magnetic Reset switch
The magnetic reset switch can be used to wake-up sensor from deep-sleep mode before its installation.
Magnetic Reset switch is a component, located in the external side of the PCB. To activate the switch is
necessary to close to it a magnet for 3 times with a frequency of 1 second (more or less), even outside the
case, in the position shown in the figure. To individuate the exact position outside the case, where apply
the magnet, the reference is the arrow on the top of the case (see the red dot in the right pic.). It is necessary
to pass with the magnet close to that point for 3 times with a frequency of 1 second (+/-).
Figure: Reset switch position in the PCB and in the complete sensor
In the complete sensor, the red dot
Indicates the reset switch position