Installation Guide

Tips:

The mirror can be Horizontally Mounted

or Vertically Mounted.

Connect the mirror wires with your main

wires and hang the mounting hole to

the screw on the wall.

Peel oﬀ the protective ﬁlm and clean the

mirror with a soft cloth.

Measure the distance of the mounting

hole, Drill holes with a suitable sized

drill.

Insert the anchor and mounting screw

into the wall.

Note: Keep the plastic corner protectors on until installation is fully completed.

1. Installation

IMPORTANT INFORMATION

To avoid the risk of electrocution,

please turn OFF the electricity supply mains

before commencing the installation.

Do not stand the mirror upright on hard

surfaces whilst ﬁtting as this will damage the edge.

Keep the plastic corner protectors on

until installation is fully completed.

PAGE 1
IMPORTANT INFORMATION To avoid the risk of electrocution, Tips: The mirror can be Horizontally Mounted or Vertically Mounted. please turn OFF the electricity supply mains before commencing the installation. Do not stand the mirror upright on hard surfaces whilst ﬁtting as this will damage the edge. Keep the plastic corner protectors on until installation is fully completed. 1. Installation Note: Keep the plastic corner protectors on until installation is fully completed.
PAGE 2
. Power Connection Instruction The mirror comes with a 5 ft power cable that can be directly plugged into the switch for convenient use. It can also be hardwired by cutting oﬀ the plug and control the ON/OFF of power via the wall switch. Warning: Removing the plug connector will invalidate your product warranty. If you would like to test the product function prior to installation, please test the product in any standard plug socket.