Instructions / Assembly

Please read carefully and save these instructions

Don't discard any of the packaging until you are sure that you have all of the parts and the fitings

Make sure power to the junction box is off before commencing installation.

IMPORTANT

1. Unpack LED cabinet. DO NOT lay cabinet on tiled or concrete surface prior to installation

Cabinet must be on protected surface to prevent chipping of the corners

2. Care must be taken before drilling pilot holes to avoid any existing wiring or pipe work that may

be concealed.

3. A certified electrician must perform all work.The mirror must be connected to a GFI

INSTALLATION

Please refer the installation diagram on installations manual.

1) Unpack the LED medicine mirror and prepare tools needed.

2) Use the tape measure the height, and draw the horizontal. Measure the distance of the hole,

and mark the hole place on the wall

3) Drill holes,and put in the plastic expansion bolt,then fix the aluminum bar by screws

(See Pic.3&Pic.4);

4) Connect hardwire to power line.Make sure the power off(Voltage:AC110-12V,50/60Hz)

5) Hang the cabinet on the wall; don't remove your hands until its safety.

6) Connect the lower end of wall with the cabinet body by using the coner brace.

MAINTENANCE

Wipe clean with a soft damp cloth. Apply glass cleaner to cloth and do not apply directly to mirror

Never use abrasive cleaners as these could damage the finish or exposed LEDstrip 2

INSTALLATIONINSTRUCTIONS

APPLY TO THE BELOW STYLE OF LED MEDICINE CABINET