Installation Guide

It is recommended that the unit is cleaned with a soft,dry, non abrasive cloth when
turned off. Never use cleaning agents or abrasive materials on any type of surface
finish. Do not allow moisture to come into contact with the electrical components.
CLEANING
Wear suitable eye protection when drilling. Take care when using power tools. Beware
of hidden cables or pipes. Take care if drilling on tiled surfaces in case the drill slips. A
piece of masking tape applied to the wall before marking out the fixing holes will stop
the drill from wandering.
INSTALLATION CARE & SAFETY
Always switch off the electrical supply at the main during installation and maintenance.
It is recommended that the circuit breaker is switched off for the necessary circuit
before installation commences.
Fitting in Bathrooms is subject to the appropriate building code Regulations. This
product is NOT suitable for outside zones. It is also Not suitable for installation in
saunas, steam rooms or shower cubicles. This product is only suitable for permanent
installation. DO NOT connect to a trailing plug and socket outlet. This product is only
suitable for indoor use. Do not attach the product to surfaces that are damp or
otherwise electrically conductive.
IMPORTANT
All connections must be installed by a licensed electrician, in accordance with current
building codes. Consult a qualified electrician.
ELECTRICAL SAFETY INSTRUCTIONS
STEP 01: Check the wall.Make
sure that the wall is bearing walls
that can support the Mirror’s
weight. Measure the width and
height of the mirror back holes/hocks
distance with a tape measure.
STEP 02: Mark the punching
position on the wall with a pencil.
Use level gauge make sure the
hole at the same level.
STEP 03: Use impact drill punch
holes in the marked center (6-8MM
drill bit),the drilling depth is about
5CM.Use a hammer to drive the
expansion screw into the drilled
hote.
STEP 04: Use screwdriver screw
the screw into the expansion screw,
tighten. And then leave a distance
of about 5MM from the wall.
STEP 05: Hand the mirror up with screw.
INSTALLTION TOOLS NEEDED
INSTALLTION MANUAL
MANUAL INSTRUCTION
DO NOT strike glass components with hard or pointed items. DO NOT place very hot
or very cold items against or in close proximity to glass surfaces unless an adequately
thick insulation material is used to prevent such items coming in contact with the glass.
The nominal thickness of the mirror glass used in this product is 1/4” and is film
backed for safety. If the glass becomes chipped or broken replace immediately.
IMPORTANT
1) Short Touch Button (<1s) to turn the task light ON/OFF. white is ON,
blue is OFF.
2) Short Touch Button (<1s) to change color temperature from 2800K to 6000K,
and cycle.
3) Press the Button to turn the defogger ON/OFF. white is ON, blue is OFF.
HOW TO USED DEFOGGER SWITCH AND DIMMER SWITCH ?