User's Manual

Never allow the battery pack to become hot during charging - this will cause
permanent damage. Warm is okay - hot is not!
-Never leave a battery unattended while it is being charged.
-Never recharge a hot battery. Always allow it to cool before recharge.
-If the battery is not completely discharged before recharging, the charging
time may be reduced. Again, do not allow the battery to get hot!
-The AC adapter should be examined periodically to ensure that it is
undamaged. Failure to do this may result in the risk of fire, electric shock, or
injury to people. In the event that the adapter shows signs of abuse, it should
not be used until repaired by a certified technician.
-Install or replace the batteries by adult only.
- Do not overcharge the battery pack by letting it charge for too long.
-Rechargeable batteries are to be charged only under adult supervision.
Battery Installation for the Transmitter:
The transmitter comes with a telescopic antenna, please insert the antenna to
the top portion of the transmitter. The Transmitter requires one 9-Volt battery
(available separately). For the best performance and longest life, we
recommend an alkaline battery. Follow these steps to install the battery in the
transmitter.
1. Remove battery compartment cover by sliding it in the direction of the
arrow shown on the compartment cover.
2. Place the battery in the compartment according to the polarity symbols (+
and -) marked inside.
3. Replace the cover and snap it shut. When the transmitter range decreases,
replace battery