User's Manual

INS-41011USEU-60322

Open the Battery Compartment & Remove the Battery

1) Open the battery compartment located at the rear of the snowmobile, by gently pushing down

while pulling backwards on it.

2) Gently pull out the battery connector and the battery.

3) Unplug the battery from the snowmobile by depressing the catch located on one side of the

connector, and pulling the plug halves apart.

Charge the Battery Pack

1) After each snowmobiling session, remove the battery pack from the snowmobile and allow it to

cool before recharging. Failure to do so will significantly shorten its lifespan.

2) Connect the output plug of the charger to the input plug of the battery pack. Notice that the plugs

can only be connected in one orientation - do not force them.

Install the Battery

Installation is simply the reverse of removal.

! IMPORTANT

1) Never allow the battery pack to become hot during charging - this will cause permanent

damage. Warm is okay - hot is not!

2) Never leave a battery unattended while it is being charged.

3) Never recharge a hot battery. Always allow it to cool

4) If you use an after-market charger, never charge the battery at a rate greater than 1000 mA.

5) If the battery is not completely discharged before recharging, the charging time may be

reduced. Again, do not allow the battery to get hot!

6) The AC adapter should be examined periodically to ensure that it is undamaged. Failure to do

this may result in the risk of fire, electric shock, or injury to people. In the event that the adapter

shows signs of abuse, it should not be used until repaired by a certified technician.

Specifications

Some versions of the Snowmobile include a battery pack and charger. Specifications (subject to

change without notice) are listed below.

R/C snowmobile battery information

USA & Canada version

Charger

Input: 120 V AC, 60 Hz, 13 W

Output: 12 V DC, 300 mA

Charge Time: 4 hours

Battery

Output Voltage: 9.6 V

Capacity: 600 mAh

(North American charger shown above)