Operation Manual Program Distributor PO-6106 * Rack mount products in the Western Hemisphere(North America, South America, and the Caribbean) do not have handles installed due to customer preference.
PROGRAM DISTRIBUTOR Welcome A personal welcome to you from the management and employees of Inter-M All of the co-workers here at Inter-M are dedicated to providing excellent products with inherently good value, and we are delighted you have purchased one of our products. We sincerely trust this product will provide years of satisfactory service, but if anything is not to your complete satisfaction, we will endeavor to make things right.
PROGRAM DISTRIBUTOR Contents Unpacking .......................................................................................................................................2 Installation Environment....................................................................................................................................2 Important Safety Instructions.............................................................................................................2 Features............................
PROGRAM DISTRIBUTOR Unpacking Although your PO-6106 is neither complicated nor difficult to operate, we recommend you take a few minutes to read this brief manual and familiarize yourself with the important information regarding product features, setup and operation. As with most electronic devices, we strongly recommend you retain the original packaging. In the unlikely event the product must be returned for servicing, the original packaging (or reasonable equivalent) is required.
PROGRAM DISTRIBUTOR Features - EASY TO OPERATE Distributes a single channel input to six outputs. - EASY LEVEL ADJUSTMENT Front-panel input and output level adjustment. - INPUT MONITORING Input peak LED monitoring. Operation 1. Make certain that speakers and input sources are properly connected before turns on. 2. Keep volume levels turned down before switching on. ※NOTE : The system’s operation is delayed by approximately three seconds after pressing the power switch.
PROGRAM DISTRIBUTOR Front Panel 1. INPUT PEAK INDICATOR This LED lights to indicate the input level is too high. 2. OUTPUT INDICATORS These LEDs indicate signal on their associated outputs. 3. POWER INDICATOR When the unit is on, this power indicator LED is lit. 4. INPUT LEVEL CONTROL This knob provides continuous control of the input level. 5. OUTPUT LEVEL CONTROL This knob provides continuous control of the output level for each of the six outputs. 6.
PROGRAM DISTRIBUTOR Rear Panel 1 2 OUTPUT INPUT 3 CH 6 CH 5 CH 4 CH 3 CH 2 CH 1 4 1. LINE INPUT Line-level input on balanced XLR connector. 2. LINE OUTPUTS 1-6 Line-level outputs on balanced XLR connector. 3. AC POWER INPUT Connect a standard three-pin AC cable to this connector. 4. DC POWER INPUT These terminals are provided for the connection of DC battery power. Connect a 24V DC battery source to these terminals.
PROGRAM DISTRIBUTOR Applications 6 PO-6106
PROGRAM DISTRIBUTOR Block Diagram PO-6106 7
PROGRAM DISTRIBUTOR Specifications PO-6106 Channels 1 Input, 6 Outputs Frequency Response 20Hz-20kHz (±3dB) T.H.D at 1kHz, Rated Output Less than 0.1% Input Sensitivity/Impedance 1V/600Ω Balanced Output Level/Impedance 100mV/600Ω Balanced S/N Operating Temperature Power Source Better than 75dB -10°C ~ +40°C / 14°F ~ 104°F 100–120VAC or 220–240VAC; 50/60Hz, DC 24V (Supplied AC main transformer depends on country requirements) Power Consumption 8W Weight (SET) Dimensions (SET) 4kg/8.
PROGRAM DISTRIBUTOR ※ DIMENSIONS 280 440 44 482 PO-6106 9
PROGRAM DISTRIBUTOR Service Procedures Take steps to insure the problem is not related to operator error or other products within the system. Information provided in the troubleshooting portion of this manual may help with this process. Once it is certain that the problem is related to the product contact your warranty provider as described in the warranty section of this manual. Schematic A Schematic is available by contacting your warranty provider.
NOTE PO-6106 13
NOTE 2 PO-6106
PO-6106 3
Inter-M, Ltd. (Korea) began operations in 1983. Since then, Inter-M has grown to become one of the largest manufacturers of professional audio and commercial sound electronics equipment in the world. Inter-M has gained worldwide recognition for its own branded products, as well as private label manufacturing of electronics sold under other names (OEM).
