Brochure

1. FAN

Airflow intake multi-stage quiet fans ensures amplifier cooling.

2. PROT (protection circuit indicators)

LED indicator displays if the amplifier protection mode.

3. POWER LED

LED indicates power ON / OFF status five times as this unit is

lit if the power switch ON and work instructions.

4. OUTPUT LEVEL INDICATOR

LED indicates output power level.

5. POWER SWITCH

An LED indicator confirms power on status of the amplifier.

1. OUTPUT TERMINAL

Allows selection of low impedance, 70.7 or 100 volt high

impedance output.

2. LEVEL ADJUST VOLUME

Rear mounted trim pot offers -12dB volume adjustment the

nominal output. (Variable output voltage of up to 75%).

3. VENTILATION

Ventilation out-take.

4. AC POWER INPUT

117VAC/60HZ 220 VAC50HZ

5. FUSE

6. HPF Switch

400Hz, High Pass Filter On/off switch

7. Signal input terminal

Phoenix-style terminals

8. Ground Lift Switch

This switch provides for connection or disconnection of the

amplifier’s ground to AC “earth” ground, to prevent noise from

ground loops. Under most circumstances, this switch should be

set to FRAME position.

9. 24V DC back up power

These terminals are provided for the connection of backup

battery. Connect a 24VDC(100A) battery source to these

terminals. Make certain the red terminal is connected to the

battery’s positive (+) side, and the black terminal to the battery’s

negative (-) side.

www.inter-m.com

1 2 3

4 5

1 3

4 5 6 7 8 9

Front / Rear Panel