Operating Manual

AUTOMATED REMOTE MESSAGE

ARM-911

Web-browser Interface Configuration

1. Accessing to the ARM-911 Web-browser

Connecting the TCP/IP port to your computer. Change the IP address of the computer (ex. 192.168.1.100)

and change the Gateway to 192.168.1.99. Access to the web-browser by typing in the address bar of your

internet browser such Explorer, Firefox or Safari the factory default IP address (192.168.1.99). If the IP

address of the ARM-911 has been set to something different then use that address. You can reset the

ARM-911 to factory default by pushing the RESET button for more than 5 second. The unit will be reset to

default mode.

When the web server is connected normally, user verification window will pop-up.

Type in the web ID and password as below.

USER ID: admin

Password: 1

If User ID and password are correct, then the browser should connect to Control Interface.

2. Network Setting

This page allows you to set-up the device Host Name as well as setting DHCP or fixed IP.