User Manual
Disposal of old electronic equipment:
The devices marked with this symbol are subject to the European Direcve 2012/19/
EC. All electrical appliances and old electrical appliances must be disposed of separate
from the municipal waste stream via designated collecon facilies appointed by the
government or the local authories. You avoid environmental damage with the proper
disposal of old electrical equipment.
Packaging:
Packaging is raw material. The packaging material of this product is suitable for recycling
and can be re-used. Please pay aenon to the local recycling provisions when disposing
of any materials.
EN - Page 5 of 6
c) Watch
You can charge your Apple Watch on the watch area (upper area behind the stand). Apple Watches as of
series 3 are supported. The charging process starts automacally and is indicated by the watch.
If the charging process does not start, please check,
a. whether the device to be charged supports the Qi standard and whether your smartwatch for the
watch area is an Apple Watch series 3 or newer.
b. whether there is a foreign object between the devices or you are using an unsuitable case.
c. whether you have chosen the enclosed quick-charge power supply or a dierent but compable
one. If this is not the case, replace it accordingly.
d. whether you have rst established the power supply and only then started the charging process. If
not, please disconnect both devices from each other and unplug the power supply for a few seconds.
Then plug the power supply unit back into the socket and only then start the charging process.
e. whether the cable ends and the power supply unit are correctly connected.
Please note that the ambient temperature and the charging electronics of the device to be charged have
an eect on the charging behaviour over which the inducve charging staon itself has no inuence. For
example, the charging speed can be reduced at increased temperatures or already reached charging levels,
the charging process – especially with the watch – can be briey interrupted or briey fail to make any
charging progress.
Step 3: End charging process
To end the charging process, simply remove your device from the inducve charging staon.
SERVICE/DISTRIBUTOR
INTENSO INTERNATIONAL GMBH I Kopernikusstraße 12-14 I D-49377 Vechta
Email (technical support): support@intenso-internaonal.de
Email (RMA number): rma@intenso-internaonal.de
Internet: www.intenso.eu
Telephone (technical support): +49 (0) 4441 – 999 111
(Mon. – Thur. 09:00 – 16:30; Fri. 09:00 – 14:00)
DISPOSAL