User's Manual

Linking Wireless Transmitters & Wireless Speakers/Receivers

Before initial use, you must link the wireless transmitter (TX) with the wireless speakers/

transceivers (in RX mode). Follow the simple steps below to perform this linking procedure.

You can link up to 8 wireless speakers/transceivers (in receive mode) to the transmitter.

To simplify the process, it is recommended that you do the below process with the transmitter

and receivers in close proximity to each other to avoid having to run back and forth between

them.

Note - The receivers will retain their link to the transmitter, even after being powered down and

moved to their nal location.

Linking Procedure

(Note - linking procedure needs to be done on each wireless speaker receiver, one at a time)

1. Switch MODE to TX and connect power cord to the transceiver.

2. Power on other transceivers (in RX mode) and/or wireless speaker you are linking to. The

Status LED on the these units will ash slowly.

3. Press the link button on the TX. The Status LED will ash quickly.

4. Press the link button of RX or Speaker. The Status LED will ash quickly.

5. If the pairing of TX and RX is successful, the status LED of both TX and RX will be SOLID.

Note - If the pairing is not successful, after one minute, the status LED of the TX will go back to

ON and LED on the RX will return to ashing slowly.

Adding Additional Wireless Speakers/Receivers

After initial setup, you can add additional wireless speakers/transceivers (in RX mode) to the

system at any time by following the same procedure. When adding new wireless speakers/

transceivers to the system, you only need to perform the procedure on the new wireless speak-

ers/receivers.

Set Up

TX Card

Link Button

Wireless Speaker

Link Button

Wireless Transceiver

Link Button