User's Manual

7
Connections
Player Setup
Wireless System Setup
The Eos Pro Series Wireless Transceiver can act as either a transmitter (TX) or a receiver (RX).
In TX mode the transceiver can send wireless audio signal to either Eos Wireless Speakers
(EOSP-622) or another Eos Transceiver in RX mode. In RX mode it can receive wireless audio
from either the EOSP-500 Dual Zone Music Player with the EOSP-510 wireless transmitter card
installed, or from another EOSP-610 transceiver in the TX mode.
Placement
For best results, the transceiver should be located at least 6’ (2m) away from a WiFi router or
other radiating 2.4GHz device.
Zone Select
The transceiver can transmit or receive over either Zone 1 or Zone 2. When transmitting over
either zone, the wireless speakers/receivers must have the same Zone selected in order to
receive the signal.
TX Mode
1. Connect the power adapter to wall outlet and plug the connector to player’s power jack.
2. Connect Audio Source to player
3. Set mode switch to TX (transmit)
4. Link wireless speaker/transceivers (in RX mode) to the Transceiver by following the
directions on page 9.
RX Mode
1. Connect the power adapter to wall outlet and plug the connector to player’s power jack.
2. Connect to audio input of amp, phone system or other audio equipment.
3. Set mode switch to RX (receiver)
4. Link wireless with TX unit by following the directions on page 9.
Transmit (TX) Mode
music player
power amp
Receive (RX) Mode Receive (RX) Mode
wired speakers
POWER AMP
music-on-hold in
PBX or Key
System