User manual

17
Parameter Description
Connect Information It is the setting for WPA or WPA-PSK mode.
Protocol This adapter supports two kind of protocol for authentication
including TLS and PEAP. TLS and PEAP requires a certificate
which is provided by the Certificate Server. PEAP requires a set
of user name and password in addition. To get the certificate and
the personal user name and password, please contact with your
administrator.
TLS – Select a certificate from the “Certificate“ list.
PEAP – Input the “User Name“ and “Password“ and also select a
certificate from the “Certificate“ list.
User Name It is the setting for PEAP protocol. The “User Name“ should be set
in RADIUS Server.
Password It is the setting for PEAP protocol. The “Password“ should be set
in RADIUS Server.
Pre-shared Key It is the setting for WPA-PSK mode. Enter 8 to 63 digits of ASCII
format to be the password for the authentication within the
network.
Certificate All the available certificates for TLS or PEAP will display in the
list. Please select a proper certificate for the wireless
authentication.
Note that the certificate of wireless station should be imported to
the Browser such as Internet Explorer. To review if the certificate
has been imported properly, please follow the steps below.
1. Open “Internet Explorer“.
2. Select “Tools“ from menu bar and then select “Internet
Options“.
3. Click “Content“ tab and then click “Certificates“.
WEP Key If the AP uses WEP data encryption function, please Click “WEP
KEY SETTING“ to setup the WEP key.
WEP KEY SETTING Setup the four sets of WEP key by clicking the button.
Change/Apply Click “Change“ will enable you to setup the WPA setting. In the
meantime, the button will change to “Apply“ for you to confirm
your settings.