User manual
11
3.4 Advanced Setting
The “Advanced Setting” allows user to enable/disable power saving mode, setup the
fragmentation threshold and RTS/CTS threshold of the adapter.
Parameter Description
Power Saving Mode
Enable auto power
saving
Check the check box to enable power saving mode. You may
control the power consumption of the adapter by adjusting the
save power level from 1 to 4. The higher power save level
selected, the lower power used. Note that lower power is supplied
may slow down the transmission rate of the adapter.
Fragementation Threshold The value defines the maximum size of packets, any packet size
larger than the value will be fragmented. If you have decreased
this value and experience high packet error rates, you can
increase it again, but it will likely decrease overall network
performance. Select a setting within a range of 256 to 2305 bytes
.
Minor change is recommended.
RTS / CTS Threshold Minimum packet size required for an RTS/CTS (Request To
Send/Clear to Send). For packets smaller than this threshold, an
RTS/CTS is not sent and the packet is transmitted directly to the
WLAN. Select a setting within a range of 0 to 2305 bytes. Minor
change is recommended