User manual

99
CONFIGURATION UTILITY
The “Set All Devices” button is used to change the logical network of all devices
that appear on the Main panel for which the password had been entered for the
same logical network. A dialog window will appear to report the success of this
operation. For devices in which the passwords were not entered, this operation will
fail and will report a failure message.
Diagnostics Tab
The Diagnostics tab brings up the diagnostics screen, which shows system
information and a history of all remote devices seen over a period of time. This
screen is available for OEM/ODM customization.
The upper window shows technical data concerning software and hardware
present on the host computer used to communicate over HomePlug on the AC
power line network. It includes the following:
• Operating system platform/version
• Host network name
• Username
• MAC address of all NICs (network interface cards) connected to the host
• Identification of versions of all driver DLLs and libraries used (NDIS)
• HomePlug chipset manufacturer name (Turbo Only devices)
• MAC firmware version (Turbo Only devices)
• MAC addresses of all devices connected locally to the host
• Version of the configuration utility
• Vendor name