User manual

1111
TROUBLESHOOTING / SPECIFICATIONS
5. troubleshooting
Problem: None of the LEDs light up after installing the bridge.
Solution: Unplug the Category 5 Ethernet network cable from the computer. Unplug the
bridge from the electrical outlet. Repeat the hardware installation process. Make
sure the electrical outlet is working properly.
Problem: The Ethernet LED does not light up on the bridge.
Solution: When the Ethernet port detects a LAN connection, the Ethernet LED will light up.
Check the computer’s Ethernet adapter to see if the connection and adapter are
working properly. Be sure you’re using the included Category 5 Ethernet network
cable (which is straight-through) to connect the bridge to your computer. Do not
use a crossover cable.
Solution: For use with a router, connect a straight-through, Category 5 Ethernet network
cable to the uplink port of the router; or connect a crossover, Category 5 Ethernet
network cable to a LAN port on the router.
Problem: When scanning the network, not all of the devices can be detected.
Solution: Make sure all devices on the HomePlug network have been configured with the
same network password. The network password must be identical for them to
communicate with each other. See Section 4.
Problem: Can’t connect to the Internet or other computers on the network.
Solution: Make sure the IP address and TCP/IP protocol are set up correctly for all the
networked computers. For more information on IP addresses and TCP/IP, refer to
your Windows help or documentation.
Solution: Make sure all devices on the network have been configured with the same
network password. The network password must be identical in order for them to
communicate with each other. See Section 4.
6. specifications
General
• IEEE 802.3 10Base-T
• IEEE 802.3u 100Base-TX
• HomePlug 1.0 Turbo
• Effective throughput: up to
25 Mbps
• Chipset: Intellon INT5500 &
RTL8201
Ports
• One 10/100 RJ-45 port
• One AC powerline port
LEDs
• Power: On = solid green
• Powerline: Link = solid green,
Act = blinking green
• Ethernet: Link = solid green,
Act = blinking green
Physical Characteristics
• Dimensions (W x D x H):
103 x 71.4 x 27.8 mm
(4 x 2.8 x 1.1 in.)
• Weight: 5.4 oz. (153 g)
• Operating temperature:
0 – 40°C (32 – 104°F)
• Operating relative humidity:
10 – 90%, non-condensing
• Storage temperature:
-25 – 75°C (-13 – 167°F)
• Storage relative humidity:
0 – 95%, non-condensing
• Power: AC 100 – 240 V /
50 – 60 Hz / 0.5 A
Certifications
• FCC Part 15, Part B, Class B
• CE Class B
Minimum System Requirements
• Existing Ethernet network
adapter
• TCP/IP protocol
• CD-ROM drive
• Configuration utility requires
Windows 98SE, Me,
2000, XP or Vista
Package Contents
• HomePlug Turbo Ethernet
Bridge
• Setup CD-ROM with user
manual
• Ethernet network cable
• Quick installation guide