User manual

switch to the “PC” side. If after connecting the Ethernet cable from the unit to your

network/system and the LAN link light does not turn on, move the switch to the alternate

position.

Note: Turn the NAS off then turn it back on to get an IP address from the network.

Ethernet Port

The Ethernet port is used to connect to a PC, server, hub,

switch or other network device on the LAN.

Reset Button

If you forget your password and/or unit IP address, you will not

be able to access the NAS. You can use the Reset Button to

restore the factory settings. To initiate a reset, you must hold the

button for at least 5 seconds or until the unit stop beeping.

The primary default settings are listed in the following table.

Configuration Item Default Settings

Administrator Username <empty>

Administrator Password admin

Internal IP address Dynamically Assigned (DHCP Client)

Power Button

Turns the unit on/off. Press lightly once. The unit will write

all data into the drive and safely power down. To force the

unit to power down immediately, press and hold the

button until the power is off.