User manual

23
Event Configuration
This section describes how to configure the NETWORK SPEED DOME Camera's alarm handling.
The camera can be configured to perform different actions when a defined type of event occurs.
Event Server
E-mail and FTP Server settings.
SMTP (email) to send captured images/video
Check Enabled to activate the SMTP (Simple Mail Transfer Protocol) service of the camera, which allows
the camera to send you short AVI videos to your e-mail address.
SMTP Server: Enter the SMTP Server address. This is your outgoing e-mail server. If you are not sure what
to enter here, contact your network administrator or your Internet Service Provider.
You can enter the IP Address (e.g., 123.456.789.123) or the domain name (e.g., smtp.yourdomain.com) of
the SMTP Server.
Email address from: This is the e-mail address the camera uses to send out e-mails. It is the sender e-mail
address. It is important to fill this field with contents to make sure the e-mails sent by the camera do not get
blocked by other E-mail Servers on the Internet as many E-mail Servers consider e-mail without a sender
address to be spam. The e-mail address does not need to be a valid e-mail address as it is only used for
sending. An example would be: [e-mail].
Email address to: The e-mail address the camera sends the e-mails to. This can be any standard e-mail
address.
Email subject: The title of the e-mail, e.g., "Alert – motion detected!"
SMTP ID: Enter the user ID for SMTP authentication. Most Sendmail servers require the client to
authenticate before sending out an e-mail. If you are not sure what to enter here, contact your network
administrator, or your Internet Service provider.
Password: Enter the Password for SMTP authentication. If you are not sure what to enter here, contact
your network administrator or your Internet Service provider.
FTP to send captured images/video
Check Enabled to activate the FTP (File Transfer Protocol) service of the camera to upload captured images
and video to the dedicated FTP server.
FTP Server: Enter the IP Address or domain name of the FTP server. Do not put "ftp://" in front of the IP
address or domain name. ftp.intellinet-network.com would be correct, whereas ftp://ftp.intellinet-
network.com would be false.