User manual

20
PTZ Control
This screen allows you to store up to 20 presets and to create a guard tour (sequence of steps automatically
performed by the camera).
Preset setting
Follow the steps below.
1. Use the PTZ controls below the image to move the camera to the desired position.
2. Select a preset no. from the drop-down list ([home] to [P19]).
3. Enter preset name (e.g., door) and click "Save >>" to save the preset.
4. The new preset appears in the list box.
5. Click “Move” to recall any preset you select from the list box.
Tour setting
You can program a patrol tour. That is a sequence of preset positions which the camera cycles through
automatically. Check Enable to activate Tour setting.
Display time
This defines the wait time between two positions. Be sure to allow enough time between two steps to allow
the camera to completely move from one position to the next. Possible values are from 0 to 600 seconds.
We recommend setting the value to at least 5 or higher.
Select preset name
Select a preset name from the drop-down list and click "Add >>". You can choose from up to 20 presets in
the preset list. Click "Save" to save the settings and click "<< Tour >>" to check the programmed patrol.