User manual

11
Zoom In / Out
Control the zoom factor of the image.
Focus In / Out
Click to adjust the focus manually. By default, the Auto Focus option is enabled, but you can manually take
control of the focus. When you move the camera to a different position with the arrow buttons, the auto
focus mode is automatically re-engaged.
Auto Focus
The camera automatically adjusts the image focus (recommended use).
Tour / Patrol Mode
If you have programmed a sequence of PTZ presets, you can activate the "Guard Tour" by clicking on this
button. When the tour mode is active, the High-Speed Dome Camera will continuously move from one
position to the next and loop through the programmed presets. To stop the tour, press
button in the
center of PTZ control field.
Relay closed / Open
Click this button to manually start and stop a connected device; e.g.,, a light switch. The device must be
connected to the internal terminal block of the camera (see Installation Guide for details). Only authorized
users can activate this function.
Trigger On / Off
This button activates trigger settings of the camera manually.
Once you press "Trigger On” the configured trigger condition and setting will be activated (e.g.,, an e-mail
will be sent, an AVI file will be uploaded via FTP).
Admin Menu
Displays the Administrator menu. (See “1.1 Configuring the Network Speed Dome camera” on page 15 )
The link is only available for the authorized administrator.
PTZ Control Field
It is possible to move the camera to pre-programmed positions. You can
access 10 presets directly through buttons 1 – 10. You can access all 20
programmed presets by selecting P1 – P20 from the drop-down list. By default,
this list is empty, as no presets are programmed. For information on setting up
preset positions, see “PTZ control” on Page 21.