User manual

10
Menu Section
Recording / Snapshot
These buttons activate recording of streaming video (DivX) or still images (BMP).
AVI Recording
Click the record
button to start recording
Type the file name and specify the destination of the video file and click "save". The recording now begins.
The camera creates a new file once every 10 minutes until you press the record button again or until your
computer runs out of disk space.
Take Snapshot
Click on the camera button and specify the location and file name of the snapshot and click "save". The
camera saves a BMP still image.
Mic / Speaker (only models with Audio support)
These buttons activate the audio functions of the camera. The microphone symbol activates the PC
microphone and allows you to send audio data back to the camera. The speaker symbol enables or disables
the audio playback of data sent from the camera to your computer. These buttons may not be active,
depending on the user account settings.
Expansion
The digital zoom function allows you to change the image size of the live image in the Web browser. You
can chose among 0.5x, 1x, 2x and 4x magnification. Please note that this function does not change the
physical resolution of the image. It only provides a digital zoom that electronically resizes the image, which
can lead to decreased quality of the picture.
.
Panning and Tilting
You can pan and tilt the camera using the 8 direction arrow buttons.
Click
to stop moving the camera. Observe the monitor image and click the
arrow button indicating the direction in which you want to move the camera. Hold
down the arrow button to move the direction of the camera continuously.
Adjust the movement speed
When using a high zoom factor, it is difficult to control the movement. Control the
speed of the movement with this slider. Move to position "S" to slow down the
movement and to position "F" to speed up the movement.
Panning and Tilting by clicking the Monitor Image with the mouse
You can operate panning, titling and zooming of the camera by clicking with the mouse on the monitor
image. Left click the area you with to see centered, then move the mouse pointer to the center of the image
and release the left button. The camera will then move the area to the center of the image.