Instructions

Server & Network

Cabinets

Assembly Instructions

SNCAB-INST-ICG-0915-01

Front Door

Side

Panel

Rear Panel

Bottom Cover Adjustable Feet

Top Cover

Attach the Adjustable Feet to the Bottom Cover

Set the

Vertical

Proles

on the

Bottom

Cover

Insert each

prole as

shown

Secure

the Vertical

Proles on

the inside

using M5x12

Phillips-head

screws

Note: Cable

entry is at

the rear

Do not

overtighten:

It can damage

the screws

Rear

Front

Tools Needed

PAGE 1
Server & Network Cabinets 1 Attach the Adjustable Feet to the Bottom Cover Rear Assembly Instructions Top Cover Rear Panel Note: Cable entry is at the rear Front Insert each profile as shown 2 Set the Vertical Profiles on the Bottom Cover Front Side Panel Front Door Bottom Cover Tools Needed Adjustable Feet 3 Secure the Vertical Profiles on the inside using M5x12 Phillips-head screws Do not overtighten: It can damage the screws SNCAB-INST-ICG-0915-01
PAGE 2
4 Set the Top Cover on the Vertical Profiles Rear Attach the Rear Panel Supports 8 11 Front 12 5 Secure the Top Cover from both sides 9.1 14 Attach the Side Panels Use M5x12 Torx-head screws Use M5x12 Torx-head screws Note: Cable entry is at the rear Attach the Mounting Rails to the Bottom Cover To install the Back Panel, first insert the tabs in the Bottom Cover slots Repeat Steps 9.1-9.