Instructions
26
Gigabit Ethernet PoE+ Web-Managed AV SwitchUser Manual
The following image shows the RADIUS Conguration page. From this screen it is possible to:
• Set the RADIUS server’s IP address rst.
• Add an optional RADIUS server IP address.
• Set the Authentication UDP port, the default value is 1812.
• Enable or disable Accounting.
• Set the Accounting UDP port, the default value is 1813.
• Set the shared secret key, which is used between the switch and the RADIUS server.
• Set the vendor-specic information if required.
• Set the NAS port, NAS port type and NAS type of service again if required.
• Enable or disable the roaming feature of RADIUS.
802.1X CONFIGURATION
The 802.1x standard defines a client-server-based access control and authentication protocol that prevents
unauthorized clients from connecting to a LAN through publicly accessible ports, unless they are properly
authenticated. The authentication server authenticates each client connected to a switch port before making
available any services offered by the switch or the LAN.
The following image shows the 802.1x Conguration page. From this screen it is possible to:
• Enable or disable the 802.1x protocol, which is required when authentication and accounting are being
implemented.
• Enable or disable Reauthentication, which increases network trac when enabled.
• Set the Reauthentication period; the default is 3600 seconds.
• Set Quiet Period Timer, if required.
• Set Tx-Period Timer, if required.
• Set Server timeout timer, if required.
• Set Supplicant timeout timer, if required.
• Set Max Request number, if required.
• View Max Request value.
• Client Version, the client version number.
• Enable or disable Check
Switch
Switch