Instructions

2
Connections & Indicators
LEDs
The LED indicators — Power, PoE, Link/Activity
— make it easier to monitor the switch and its
connections. NOTE: All ports provide power
to a connected device, and all connected
devices should comply with IEEE 802.3af.
Ports
All ports on the switch support Auto-MDI/
MDI-X functionality, so crossover cables and
uplink ports are not needed for connections
to PCs, routers, hubs, other switches, etc.
Cat5/5e/6 UTP/STP cables provide optimal
performance; if a status LED doesn’t
indicate a link or activity, check the corresponding device for proper setup and operation.
Power
Use the included power cord to connect the device (on the rear panel) to an
AC outlet. Confirm that the power LED on the front panel is lit.
Installation
Prior to use, it is recommended that the switch be placed/positioned:
on a level surface that can support the weight of the switch
with at least 25 mm (approx. 1”) of clearance for ventilation;
away from sources of electrical noise: radios, transmitters, broadband amplifiers, etc.;
within 100 m (approx. 328’) of network devices it’s to be connected to.
Chassis Ground Column (Rear Panel)
Wire the grounding terminal to an earth-grounding object to prevent power spikes.
Rackmount
The switch includes brwackets and screws for optional rack mounting.
1 Disconnect any cables from the switch.
2 Position a bracket over the mounting holes on one side
of the switch and secure it in place with screws.
3 Repeat Step 2 on the other side of the switch.
4 Position the switch in the rack and screw the brackets to the rack.
5 Reconnect any cables.
For specifications, visit intellinetnetwork.com. Register your
product at register.intellinet-network.com/r/560993 or scan the QR code on the cover.
LED COLOR STATUS STATUS DESCRIPTION
PWR Green
Off PWR Off
On PWR On
Link/
Act/
Speed
Yellow
Off No device is connected to the port
On
A device is connected to the
port at 10/100 Mbps speed
Flashing Sending or receiving data
Green
On
A device is connected to the
port at 1000 Mbps speeds
Flashing Sending or receiving data
PoE Yellow
Off No device is connected to the port
On
The connected device
is receiving PWR
2
4
3
&
Instructions
English