User manual

30
Community name
(write-only)
Name of the write-only community. This write-only
community allows write operation to the objects defines
as read-writable in the MIB.
When you finish, click “Apply Changes.” You’ll see the following message
displayed on Web browser.
Click “Continue” to save the settings made and go back to the Web management
interface; click “Apply” to save the settings made and restart the router so the
settings will take effect after it reboots.
5.2.2 WAN
Use the WAN Settings screen if you have already configured the Quick Setup
Wizard section and you would like to change your Internet connection type. The
WAN Settings screen allows you to specify the type of WAN port connection you
want to establish with your ISP. The WAN settings offer the following selections
for the router’s WAN port: Channel, ATM Setting, ADSL Setting, DNS, DDNS and
RIP.
5.2.2.1 Channel Config
The router supports eight ATM permanent virtual channels (PVCs) at the most.
This screen is used to configure the parameters for the channel operation modes
of your router. Before configuring the router, check with your ISP as to what kind
of service is provided, such as PPPoE, PPPoA or RFC1483/2684. Gather the
information as illustrated in the table below and keep it for reference.