User manual

29
CONFIGURATION
 ProjectorServerwillusetheIPaddressyoudenebelow.
IP Address: Enter the IP address you want to assign to the projector
server.
Subnet Mask: Enter the subnet mask of the projector server’s IP address.
Gateway Address: Enter the IP address of the gateway of your local
 areanetwork.YoucanleavethiseldblankandclientsontheLAN
will still be able to connect to the projector server, but some network
 featureswillnotfunction.Forexample,ifthetimeserveryoudeneis
not located within the local area network, the projector server won’t be
 abletoaccesstheInternetandsynchronizewiththetimeserver.
DNS Address: Enter the IP address of the DNS server (not the hostname
of the DNS server).
Secondary DNS Address: You can enter another DNS server’s IP
 addressincasetheprojectorserverfailstoconnecttotherstDNS
 server.YoucanalsoleavebothDNSeldsblankandstillenjoymost
of the device’s features. However, you do need to enter an IP address
(not hostname) for all servers required by this device (e.g., NTP server).