User manual
9
QUICK INSTALLATION
2 QUICK INSTALLATION
2.1 Connections & Conguration
Following is a quick installation procedure to get you up and running. For further
details on each of the settings, refer to subsequent sections in this manual.
1.
Install one or two hard drives. NOTE: Without installing and formatting a drive
rst, the other functions of the Gigabit SATA NAS will not be available.
2. Connect the Ethernet cable from your network router or switch to the device.
3. Model 505888: When everything is connected, turn the Gigabit SATA NAS on
by connecting the power adapter. Give it about two minutes to boot up.
Model 505895: When everything is connected, turn the Gigabit SATA NAS on
by pressing the Power switch. Give it about two minutes to boot up.
4. On the included installation CD, run the INTELLINET_nas.exe utility. If needed,
refer to Section 3: System Setup / Logging In in the manual.
5. Access the Web conguration interface via your Web browser, then refer to
Section 4: Web Conguration in the user manual.
5. Model 505888: Go to the Maintenance menu and use the disk utility to format
the drive. When only using the Gigabit SATA NAS as network drive, using EXT2
is recommended; when also using it as a USB drive, NTFS or FAT32 will be
more convenient, depending on your operating system.
Model 505895: Go to the Maintenance menu and use the disk utility to format
the drive. If two identical drives are installed, you can also go to the RAID
Setting section and create your RAID array.
6. Once the drive has been formatted, go to the Basic menu and follow the quick
setup wizard instructions. This will help you to set up the IP conguration, add
the rst user and prepare le sharing, after which you’ll be ready to start sharing
or downloading les. NOTE: Set the speed for your network card to auto and
not full or half speed.
2.2 Power On/Off Procedures
2.2.1 Model 505888 / 1.5 TB
To turn the power on, simply connect the power supply. NOTE: Always connect the
power adapter to the Gigabit SATA NAS before you plug it into an AC outlet. It’ll
take about two minutes for the network drive to go online and be ready.
To turn off the network drive, log in via your Web browser, stop all current downloads,
go to the “Turn Off Server” section in the System menu and turn the server off.
Once the system has shut down, remove the power adapter from the AC outlet.