User manual

8
HARDWARE
8. Reverse Steps 2 and 1, sliding the inner enclosure back into the outer chassis
and replacing the 4 screws in the chassis bottom.
NOTE: Be careful not to damage any cables or components during the assembly,
and make sure the cables are rmly connected.
6. Set the second hard drive in the enclosure
and connect the SATA and power cables.
7. Secure the drive using 2
screws on each side.
3. Set the rst hard drive in the enclosure
and connect the SATA and power cables.
5. Using the tape provided, attach the thermal probe (black and white wire) to the
rst hard drive. Choose a location between the two drives so the probe won’t
be damaged during the installation of the second drive.
4. Secure the drive using 2
screws on each side.