User manual

5
HARDWARE
USB device port — This USB type-A port is for connection to an external USB hard
drive, USB ash drive or USB printer.
Power adapter jack — For external USB devices, it’s recommended that the USB
drives have their own power supply.
1.1.4 Hard Drive Installation
5. Reverse Steps 2 and 1, sliding the inner enclosure back into the outer chassis
and replacing the 3 screws in the chassis bottom.
6. If desired, align the stand with the holes in the chassis and lightly snap the stand
in place.
NOTE: Be careful not to damage any cables or components during the assembly,
and make sure the cables are rmly connected.
4. Secure the drive using 2 screws
on each side.
2. Push the inner
enclosure out to
separate it from
the outer chassis.
3. Set the hard drive in the enclosure and
connect the SATA and power cables.
1. Remove the 3 screws from
the chassis bottom.
(Disengage the unit from
the stand if it’s attached.)
CAUTION! Handle the
device very carefully, as
some metal edges may
be sharp or rough.