User manual
14
SYSTEM SETUP / LOGGING IN
3. Enter “intellinet.” This is the default name of the Gigabit SATA NAS: If it’s been
changed and you don’t know the current correct name, reset the device rst to
re-establish the default settings.
4. After entering the previous command and pressing the <Enter> key, it should
return an IP address, followed by the name you just entered.
5. Open your Web browser and enter the IP address from the previous step to
access the Web conguration interface. The default username and password
are both “admin.”
NOTE: When Bonjour is disabled, you can use the Peer to Peer method to log in
and set up your network drive.
3.4 Bonjour Login
When the Bonjour service on the device is enabled, all you need to do is access
the Bonjour tab in your bookmarks folder and select the Gigabit SATA NAS.
1. Turn on the NAS, ensuring it’s connected to the same network as your computer.
2. Open your Web browser. If not already displayed, click on the bookmarks icon
to show all bookmarks.
intellinet
intellinet
intellinet