User manual
11
SYSTEM SETUP / LOGGING IN
3 SYSTEM SETUP / LOGGING IN
To congure your network drive, open your Web browser, enter the IP address,
then use the Web conguration interface for further setup. Options for identifying
your device’s IP address once it’s connected to the network are described below
.
3.1 PC Login
Open the INTELLINET_nas.exe utility on the included CD. This will list the device
automatically and allow you to access the Web conguration interface with a simple
click of your mouse. You can use the same utility at a later point to map the network
drive after you set up your shares.
1. Turn on the NAS, ensuring it’s connected to the same network as your computer.
2. Start the utility by double-clicking on the .exe le and clicking “Setup.”
3. Your Gigabit SATA NAS should automatically display in the device list. If it
doesn’t, make sure the utility has access to the network and search again.
You may need to congure your rewall or even temporarily turn it off.
4. With the utility’s Step 1: Network Storage Link(s) Have Been Found screen
displayed, select your device and click “OK” to start the setup wizard.
5. Before you can access the Gigabit
SATA NAS, you need to enter the
admin password. Enter the default —
“admin” — in the text eld, then click
“OK” to log in.