User manual

10
QUICK INSTALLATION
When using Gigabit SATA NAS as a USB drive, eject the external drive from your
system, then remove the power adapter from the AC outlet.
2.2.2 Model 505895 / 3 TB
To turn the power on, rst connect the power adapter to the Gigabit SATA NAS,
then plug it into an AC outlet. Press the Power switch. The blue backlight LED will
turn on, and the unit will start to boot up. It will take about a minute for the device
to go online and be ready. During bootup, the OS LED will be blinking.
To turn the power off, log in via your Web browser, stop all current downloads, go
to the “Turn Off Server” section in the System menu, and turn the server off or use
the Power switch. The OS LED will be blinking for about 5 seconds; the system
will shut down about 20 seconds later. NOTE: If the device is not in use for a
longer period of time, remove the power adapter from the AC outlet.
IMPORTANT: To protect your les and help prevent the loss of your data, it’s
strongly recommended that you keep two copies of your data: one copy on your
Gigabit SATA NAS and a second copy either on your internal drive or another
storage media, such as a CD, DVD, tape or additional external drive. Any loss or
corruption of data while using this Gigabit SATA NAS is the sole responsibility of
the user, and under no circumstances will INTELLINET NETWORK SOLUTIONS
be held liable for compensation or the recovery of this data.