User manual
2
ENGLISH
Fast Ethernet Rackmount PoE Switch • User Manual English
Thank you for purchasing the INTELLINET NETWORK SOLUTIONS
™
16-Port
Fast Ethernet Rackmount PoE Switch, Model 503631 (15.4 Watts/port) or
Model 524155 (7.3 Watts/port).
Connections
The 16 RJ45 connections on the front panel (partially shown below) match
workstations, servers or other network devices to 10/100 Mbps switching
ports that automatically negotiate full/half duplex mode, allowing you to
connect the switch to 10Base-T and 100Base-TX devices. NOT E: The 16 ports
also provide a 48 V power-injector PSE (power source equipment) function.
Power switch — The AC power outlet and switch are on the rear panel.
PCs, servers and other devices — Use Cat5 straight-through twisted-pair cables
to congure a network.
Hubs and other switches — Use either straight-through or crossover cable to
connect to the uplink port of a hub or another switch: This device supports
Auto-MDIX on all ports.
Powered devices — Use Cat5 twisted-pair cable to supply 48 V to a powered
device connected to any of the 16 ports. NOTE: Any connected devices should
also be IEEE 802.3af compliant.
LEDs
POWER — When lit, there is power to the switch.
PoE — When lit, the port is linked to a PoE device.
LINK/ACT — When lit, a valid port connection has been made. When blinking,
data is being transmitted or received.
POWER
2 4 6 8 10 12 14 16
1 3 5 7 9 11 13 15
2 4
1 3
PoE
PoE
LINK/ACT
LINK/ACT