User manual

22
Idle Time You can
specify an idle time threshold (minutes) for the WAN
port. This means if no packets have been sent (no one using the
Internet) throughout this specified period, then the router will
automatically disconnect the connection with your ISP. Note: Idle
time “0” means no time out, e.g. no time restriction (always On)
Click <OK> when you have finished the configuration above. Congratulations! You have
completed the configuration for the PPTP connection. You can start using the router now, if you
wish to use some of the advance features supported by this router see chapter 2, 3, 4.
Chapter 2
General Settings
Once you click on the General Setup button at the Home Page, you should see the screen
below.
If you have already configured the Quick Setup Wizard you do NOT need to configure anything
thing in the General Setup screen for you to start using the Internet.
The General Setup contain advanced features that allow you to configure the router to meet your
network’s needs such as: Bridge, Address Mapping, Virtual Server, Access Control, Hacker
Attack Prevention, Special Applications, DMZ and other functions.