User manual

6
HARDWARE
1 HARDWARE
1.1 Card Components
• After the card has been installed on the computer, screw the included antennas
onto the reverse SMA connectors (see below). It’s recommended that both
antennas be positioned at a 90˚ angle to the card initially for what is typically the
best radio reception, adjusting them as needed later.
• Press and hold the WPS button for 3 seconds to start the WPS function. When
WPS is enabled, the Link and Tx/Rx LEDs will light.
• The Tx/Rx LED is yellow and blinks when data is being transferred or received.
When it’s off, there is no wireless activity. When WPS is enabled, this LED remains
on.
• The Link LED is green. It lights when a link has been established to a wireless
access point; it goes off when the radio is switched off. When WPS is enabled,
this LED remains on .
1.2 Installing the Card
1. Turn off the computer.
2. Remove the cover.
3. Insert the card into an empty
PCI slot on the computer.
4. Attach the antennas and
position them as directed
above.
5. Replace the cover and turn
the computer on.
ANT
WPS
Tx/Rx
Link