User`s manual

(the Node ID is printed on the rear side of the print

server)

Assign IP address: 203.66.191.12

arp –s 203.66.191.12 00-00-B4-01-01-01

ping 203.66.191.12

At the mean time, print server’s IP will “temporarily”

be set to 203.66.191.12 (will restore after reboot).

Therefore, you need to run your web browser to set a

permanent IP address (refer to section 8.3.7 for detailed IP

configuration).

6.3.2 DHCP

There are many Unix systems that support DHCP

protocol, and the procedures to configure the DHCP server

database are different. This manual does not describe the

DHCP server configuration on the Unix systems. It is

highly recommended that the DHCP server should be

located on the same network as the print server.

6.3.3 BOOTP

If you have the BOOTP daemon, bootpd, running on

your UNIX system that is accessible by the print server,

you can use the BOOTP protocol to set up the IP address of

the print server. We recommend that the BOOTP server

should be located on the same subnet as the print server. If

you use Network Information Services (NIS) in your system,

you may need to rebuild the NIS map with the BOOTP

services before doing the following BOOTP configuration.