User manual
5
hARDwARE INSTALLATION
hardWare inStallation
SELECTING A SITE FOR THE SWITCH
As with any electrical device, you should place the switch where it will not be
subjected to extreme temperatures, humidity or electromagnetic interference.
Specically, the site you select should meet the following requirements:
• The ambient temperature should be between 32 and 104 degrees Fahrenheit
(0 to 40 degrees Celsius).
• The relative humidity should be less than 90 percent, non-condensing.
• Surrounding electrical devices should not exceed the electromagnetic eld (RFC)
standards for IEC 801-3, Level 2 (3V/M) eld stength.
• Make sure that the switch receives adequate ventilation. Do not block the fan
exhaust port on the switch.
• The power outlet should be within 1.5 meters of the switch.
• Do not place objects on top of the unit.
• Always avoid dust and dirt.
CONNECTING TO POWER
1. Connect the AC power cord to the receptacle on the back of the switch, then
plug it into a standard AC outlet with a voltage range from 180 to 260 V AC.
2. Disconnect the power cord if you want to shut down the switch.
CABLING
1. Ensure the power of the switch and end devices is turned off. NOTE: Always
ensure that the power is off before any installation.
2. Prepare cable with corresponding connectors for each type of port in use.
3. Connect one end of the cable to the switch and the other end to a desired device.
4. Once the connections between two end devices are made successfully, turn on
the power and the switch is operational.