User manual
37
wEb-bASED bROwSER MANAGEMENT
is automatically turned off in situations where multiple STP brdges communicate
over a shared (non-point-to-point) LAN. The bridge will automatically take point-
to-point to be true when the link is found to be operating full duplex. The point-
to-point parameter allows this behavior or operates a point-to-point link, but
cannot run the link full duplex. It will force the parameter false when the port
operates the link full duplex, but is still not point-to-point (e.g., a full duplex link to
an unmanaged bridge that concentrates two other STP bridges).
Protocol: Displays either RSTP or STP.
Port State: Displays Non-STP, Disabled, Learning, Forwarding, Blocking or
Discarding to indicate the STP status of the port.
• Non-STP: STP is disabled on this port.
• Disabled: STP is enabled on this port, but the link is down.
• Learning: The port is learning MAC addresses in order to prevent ooding when
it begins forwarding trafc.
• Forwarding: The port is forwarding trafc.
• Blocking: The port is used in the STP topology, but isn’t forwarding trafc.
• Discarding: The link is not used in the STP topology, but is standing by.
Maintenance
WARM RESTART
Yes: Click to reboot the device in software reset.
FACTORY DEFAULT
Yes: Click to reset the switch to the default conguration.