User manual
10
wEb-bASED bROwSER MANAGEMENT
Default: 0.0.0.0. This is the IP address of the user’s SNMP management station
if it is congured to receive traps and notications.
SNMP Read Community: Any 20 characters. Default: public. This parameter
identies the MIB tree(s) to which this entry authorizes read access.
SNMP Write Community: Any 20 characters. Default: private. This parameter
identies the MIB tree(s) to which this entry authorizes write access.
SNMP Trap Community: Any 20 characters. Default: public. This parameter
identies the MIB tree(s) to which this entry authorizes access for notications.
VLAN Mode: Either “Port-based” or “802.1Q VLAN” (default). Species the VLAN
mode to congure the 802.1Q-based VLAN or the port-based VLAN, or to close
the function. This device supports Virtual VLAN, which means the network can
be segmented into groups to reduce collisions caused by wide broadcasting.
The device supports both port-based VLAN and 802.1Q tag-based VLAN: Port-
based VLAN directs incoming packets to VLANs according to their ingress
ports; 802.1Q tag-based VLAN adds a tag to the header of the packet to direct
the packet to the right VLAN. NOTE: When you change the VLAN mode, the
system will reboot.
MAC Agetime (secs): 10 to 65535. Default: 300 seconds. This congures the time
a learned MAC address is held before being aged out.
PORTS
On this screen, you can congure the function of each port, including Mode and Flow
Control settings. Select the port number and set its function, then click “Apply” to save
the new settings to the device.