User manual

Restore Default Button
Use this button to reset the switch or restore factory default settings. To reset,
press the button once. To restore factory default settings, press and hold the
button for three seconds.
REAR PANEL
Power Receptacle
Plug the female end of the power cord firmly into the receptacle and the other
end into an electrical outlet. Confirm that the power LED is lit for a normal
power status.
2. INSTALLATION
DEVICE INSTALLATION
The Gigabit Ethernet Rackmount Managed Switch can be placed directly on
your desktop or mounted in a rack. Rackmounting facilitates orderly installation
when you are going to install a series of networking devices.
Prior to use, it is recommended that the device be placed/positioned:
• with a minimum of 25 mm of clearance on the top and sides for adequate
ventilation
• away from sources of electrical noise, such as radios, transmitters and
broadband amplifiers
• where it cannot be affected by excessive moisture
Desktop
1. Attach the included rubber feet to the bottom of the device to keep it from
slipping. The recommended positions are marked on the switch.
2. Place the device on a level surface that can support the weight of the switch
(and any other items that need to be considered).
Rackmount
1. Disconnect any cables from the switch before proceeding with rackmounting.
2. Place the device on a hard, flat surface with the front facing you.
3. Position one of the two included mounting brackets over the mounting holes
on one side of the unit.
4. Insert the screws and fully tighten them with a suitable screwdriver.
5. Repeat the two previous steps for the other side of the device.
6. Insert the switch into the rack (secure with suitable screws, if desired);
reconnect cables as needed.
5
INSTALLATION