User manual

5
4. Run the electrical wire from the power
source through the cable inlet (through
the Cable Manager mounting bracket
on Model 176224), then connect it to
the circuit board’s power input
connector.
5. Close and secure the cover by tightening the
screws on the side. Attach the entire unit to the
surface desired, then make final adjustments to
properly aim the camera.
GROUND
BLOWER OUTPUT
HEATER OUTPUT
CAUTION: Any electrical connections should be made and/or serviced only by a qualified
electrician/technician.
Never handle exposed electrical wiring without first disconnecting it from the power source.